Download >>> https://byltly.com/281qyn
Buon giorno! Questo manuale è una guida completa per tutti coloro che desiderano imparare a usare il termosifone! Come si apre? E come fare rottamazioni e montaggi? Scopri da subito con questa guida. Grazie per aver letto e le persone di L'Arbeid. › ‹ .Grazie al vostro apprezzamento potremmo fare ancora meglio! › ‹ . Bisogna che apprenda come lavorare. › ‹ .Buon divertimento. ‹ ‹ "Good Morning!" This manual is complete for all those who want to learn about the heater! How does it open? And how to do repairs or assembly? Find out now with this guide. Thank you for reading and the people of L'Arbeid. › ‹ .Thank you for your appreciation could make us better! › ‹ .You must learn how to work. › ‹ .Good fun. First, make sure the box is off. Then, remove the screws from the top and bottom. After you have removed all of them, pull them out. Remove all of the tape from around the door with a knife or a screwdriver. Next, unscrew all of the screws that hold it together using a screwdriver or a drill. Tape around the door may be attached to the sides as well so be careful not to break it by pulling too hard. When all sides are completely apart, pull off the handle. There will be tape holding it on as well. Unscrew the screws and place them in a safe place so you do not lose them. Take out the plastic liner and its wires with your hands. The next step is to remove the insulation from your heater. This is to avoid damaging your parts, especially if it is an electrical heater (easy). Next, unscrew and remove the thermostat inside of the heater. You can then put both of these items away so you do not lose them. Open your door by removing its screws and removing all of the pieces of tape holding it together i.e.: top, bottom, side panels etc.. Also, make sure you remove the handle from the door as well before moving on. After this, take out all of the wires from inside by pulling them out with your hands. Every wire will come out individually so you do not have to worry about making a mistake. Every wire may be labeled as well so you can tell which wire is which. Next disconnect all of the screws at the bottom of the heater and remove all of its pieces from it one by one. These pieces may include a fan, a thermostat and a pipe so make sure you do not lose anything except those parts i.e.: fan, thermostat etc.. Disconnect any parts that have been connected to each other as well. cfa1e77820
Comments